A well designed Clubhouse highlightens and adds to the value of a residential project. The following facilities are provided in a Clubhouse:
Every facility listed above has its own peculiarity and requirement as per the specific use. Therefore a clubhouse shall be planned and constructed as per the details & specifications given by the Consultants. Consultants play a vital role in planning the Clubhouse for every minute detail.
The information for some of the facilities is briefed herewith.
Jacuzzi is an arrangement of water jets, which helps to provide Massage to human body. Since the body is almost weightless when immersed in the water, even a light water jet provides a blissful Massage to the body. Salient features of Jacuzzi machine
Steam boiler is built in S.S. 304, argon welded and is tested for a pressure of 5 Kg/ sq.cm, with necessary insulation. The heater used is industrial immersion heater of S.S. and connected with Teflon coated probes. The heater is fitted inlet and drain valves, solenoid valve, level control probes etc.
Boiler Enclosure: The boiler enclosure is made in 16 SWG mild steel with proper louvers for free air circulation and is duly powder coated with chosen shades.
Control panel : The control panel consist of thermostat controller, on -off indicators, necessary printed circuit board, L&T make contactor, MCB, timer controller, display unit, relays etc.
Plumbing details: Main water supply up to the steam boiler is to be provided Steam delivery line is made in G.I.pipes from steam boiler to the steam room. These lines are insulated properly. Nahani trap is provided with the drainage in the steam room.
Total Power requirement = 9 KW.
Main cable having 4 cores and cross-section of 4 sq.mm. Main switch through ELCB and MCB with proper earthing. Operating cables from steam unit to operating panel.
One ceiling rose for fixing of light, above the false ceiling.
Steam bath is recommended for a time of not more than 10 to 20 minutes. Three persons can be accommodated in the cabin at a time. Ceiling and door of the cabin shall be made in Aluminium and wired glass.Door of the cabin shall be kept open to avoid odour. Locking arrangement shall not be provided to the door. Only hydraulic door closer shall be provided.
The required civil works includes:
Introduction : The sauna bath is nothing but a hot air bath. The hot air bath helps to sweat the body and indirectly helps to maintain the metabolism of the body.
The sauna unit consists of air heaters and with necessary control panel fitted with all safety devices. The necessary heatproof cabin is constructed in woodwork. The planks of Deodar or Canadian hemlock knotless wood are fitted on a suitable frame. The walls shall be protected from high temperature by using glass wool insulation & asbestos sheet behind the unit.
Heater : Aesthetically designed main body of the heater is manufactured in 14 gauge M.S. sheet and is powder coated. The electrical cables are thermally insulated and are totally outside the heater stove. The heating elements are of standard companies which have a unique heat distribution system. The pebbles are kept on the heater, which help to store the heat efficiently.
Control panel consists of :
DETAILS OF WOOD WORK :
Wooden frame is constructed by using deodar wood of the section size 40 mm x 50 mm, on all six sides of the cabin. The cabin is provided with Resin boded mineral glass wool insulation on ceiling and four vertical walls.
A Door frame made up of C.P.teakwood of section 100 mm x 25 mm is provided and the shutter is
provided with toughened glass and wooden planks as designed. Locking arrangement shall not be provided to the door. Only hydraulic door closer shall be provided.
Requirement at site
The steam and sauna bath help to benefit in some of the conditions of health by the use of heat. It helps in following conditions: